Seat Toledo 2016 Owner's Manual page 98

Time
To set the time, keep the button
●
pressed for more than 3 seconds to select
4
the hour or minute display.
● To continue setting the time, press the up-
per or lower part of the button
ton down to scroll through the numbers
quickly.
● Press the button again in order to finish
4
setting the time.
The time can also be set via the
function button in the Easy Connect
Setup
›››
system page 99.
Compass
With the ignition on and the navigation sys-
tem on, the cardinal point corresponding to
the direction of travel of the vehicle is dis-
played on the instrument panel.
Selector lever position
The selected gear is displayed on the side of
the selector lever and on the instrument pan-
el display. In positions D and S, and with the
Tiptronic, the corresponding gear is also dis-
played.
Recommended gear (manual gearbox)
The recommended gear in order to save fuel
is displayed on the instrument panel while
›››

page
you are driving
96
Second speed display (mph or km/h)
›››
Fig. 110 In addition to the speedometer, the speed
can also be displayed in a different unit of
measurement (in miles or in km per hour).
This option cannot be deactivated in models
. Hold but-
4
destined for countries in which the second
speed must always be visible.
The second speed display can be adjusted in
the Easy Connect system via the
the
Setup
key and

Speed warning
When the speed setting is exceeded, this will
be indicated on the instrument panel display.
This is very useful, for example when using
winter tyres that are not designed for driving
at the maximum speed of the vehicle
›››

page
The speed warning settings can be adjusted
in the Easy Connect system via the
and the
Setup
Start-Stop operating display
Updated information relating to the status is
displayed on the instrument panel
›››
page 181.
Low consumption driving status (ECO)*
Depending on the equipment, when driving,
the " ECO " display appears on the instrument
25.
Operation
key and

›››
page 99.
function button
29.
key

›››
function button page 99.
panel when the vehicle is in low consump-
tion status.
Identifying letters on engine (MKB)
›››
Hold the button Fig. 110 down for more
4
than 15 seconds to display the identifying
letters of the vehicle engine (MKB). To do
this, the ignition must be switched on and
the engine switched off.
WARNING
›››
Observe the safety warnings
and control lamps on page 98.
WARNING
Even though outside temperatures are above
freezing, some roads and bridges may be icy.
At outside temperatures above +4°C
●
(+39°F), even when the "ice crystal symbol"
is not visible, there may still be patches of ice
on the road.
● Never rely on the outside temperature indi-
cator!
Note
Different versions of the instrument panel
●
are available and therefore the versions and
instructions on the display may vary. In the
case of displays without warning or informa-
tion texts, faults are indicated exclusively by
the warning lamps.
in Warning