Ignition Lock - Seat Toledo 2016 Owner's Manual

Ignition lock

Ignition key positions.
Fig. 172
Petrol engines
– Ignition switched off, engine stopped,
1
steering can be locked
– Ignition switched on
2
– Starting
3
Diesel engines
– Fuel supply stopped, ignition switched
1
off, engine stopped, steering can be locked
– Engine pre-heating, ignition switched
2
on
– Starting
3
To engage the Steering lock without the key
in the ignition, turn the steering wheel slight-
ly until you hear it engage.
Driving
If the steering lock is engaged and it is diffi-
cult or impossible to turn the key to position
, release the lock by turning the steering
2
wheel slightly in both directions.
Starter button
In the steering column: start-up
Fig. 173
push button for the Keyless Access lock and
start-up system. The layout in right-hand
drive vehicles is symmetrical.
Emergency ignition in vehicles with
Fig. 174
Keyless Access.
The start-up button may only be used if there
is a valid key in the vehicle.
Opening the driver's door when exiting the
vehicle activates the electronic lock on the
steering column if the ignition is disabled.
Switching the ignition on/off
● Briefly push the start-up button
without touching the brake or clutch ped-
›››
al .
Emergency starting function
If no valid key is detected inside the vehicle,
an emergency start-up will be required. The
relevant message will appear in the dash
panel display. This may happen when, for ex-
ample, the vehicle key battery is very low or
flat:
›››
Fig. 173
»
151