Seat Toledo 2016 Owner's Manual page 175

● Switch the ignition on.
If necessary, switch on the Infotainment
●
system.
Engage reverse gear or turn the selector
●
lever to position R.
● Press the --- function button displayed on
the right of the image.
● Make the desired adjustments on the menu
by pressing the – / + function buttons or by
moving the corresponding scroll button.
Necessary conditions for parking and ma-
noeuvring with the rear assist
The system should not be used in the follow-
ing cases:
● If the image displayed is not very reliable or
is distorted, for example low visibility or dirty
lens.
● If the area behind the vehicle is not dis-
played very clearly or is incomplete.
● If the vehicle is heavily loaded at the rear.
● If the position and installation angle of the
camera have been changed, e.g. after a rear-
end collision. Have the system checked by a
specialised workshop.
Familiarising yourself with the system
To familiarise yourself with the system, the
orientation lines and their function, SEAT rec-
ommends practising parking and manoeu-
vring with the rear assist in a place without
Driver assistance systems
too much traffic or in a car park when there
are good weather and visibility conditions.
Cleaning the camera lens
Keep the camera lens clean and clear of snow
and ice:
● Moisten the lens using a normal alcohol-
based glass cleaning product and clean the
lens with a dry cloth.
● Remove snow using a small brush.
Use de-icing spray to remove any ice.
●
CAUTION
Never use abrasive cleaning products to
●
clean the camera lens.
Do not use hot or warm water to remove ice
●
or snow from the camera lens. Doing so could
damage the camera.
Parking and manoeuvring with the
rear assist
Display on the Infotainment system
Fig. 186
screen: orientation lines.
Switching the system on and off
● The rear assist will switch on when the igni-
tion is on or the engine running, on engaging
reverse gear (manual gearbox) or on chang-
ing the selector lever to the R position (auto-
matic gearbox).
● The system switches off 8 seconds after
disengaging reverse gear (manual gearbox)
or removing the selector lever from the R po-
sition (automatic gearbox). The system will
also disconnect immediately after the igni-
tion is switched off.
In combination with the Parking System Plus
›››
page 167, the camera image will cease to
be transmitted immediately when reverse
gear is engaged or when the selector lever is
moved from the R position, and the optical
»
173