Seat Toledo 2016 Owner's Manual page 192

Disassembly of the ball-headed bar
Fig. 201 Remove the key slot cover/unlock
with the key.
190
Operation
Unblock the ball-headed bar.
Fig. 202
Remove cover from over the regulator
–
A
key slot in the direction of arrow
›››
Fig. 201.
Insert key in the key slot.
– B
Open the manual regulator lock by turning
–
key fully to the left in the direction of ar-
B
row . The arrow on the key points to the
2
"unlocked" symbol.
Hold the ball-headed bar from underneath
–
›››
Fig. 202 and remove manual regulator
with your other hand in the direction of
C
arrow .
3
Turn the removed regulator fully in the di-
–
rection of arrow and hold it firmly in this
4
position.
Remove the ball-headed bar from the
–
clamping bush, pulling downward in the di-
rection of arrow .
5
The ball-headed bar should be placed in the
service position so that it is ready to be inser-
ted into the clamping bush
Place the cover over the clamping bush
–
›››
Fig. 195.
WARNING
Never leave the ball-headed bar unsecured
●
in the boot. It could be damaged in the event
of sudden braking, putting the safety of pas-
sengers at risk!
● Never disassemble the ball-headed bar
1
with the trailer still hitched.
CAUTION
● If you do not turn the manual regulator
fully, it will return to its original position
when the ball-headed bar is removed. The
manual regulator will be stuck to the ball-
headed bar and you will not be able to put it
in the service position. Therefore, before you
assemble it again, you must place the ball-
headed bar in this position.
● When disassembling, place the cap on the
clamping bush holder's key slot. This way
you will prevent dirt from entering the clamp-
ing bush.
Note
● Before disassembling the ball-headed bar,
we recommend placing the cover on the ball
head.
›››
.
4