Changing The Rear Lights (On The Side Panel) - Seat TOLEDO Owner's Manual

Changing the rear lights (on
the side panel)
Removing the rear light 1)
Remove the rear light unit from side
Fig. 97
panel.
Check which of the bulbs is defective.
Open the luggage compartment to access
–
the rainduct area.
Take the screwdriver or a Torx 20 key (T20)
–
from the vehicle tool kit and loosen (turn-
ing anti-clockwise) and remove the two re-
taining screws that secure the front of the
›››
light Fig. 97 , taking care not to lose
1
them.
1)
In the case of LED rear lights of the side panel only
the turn signal lamp can be changed. The illustra-
tions in the manual correspond to the bulb version
and do not correspond exactly to the LED version.
Fuses and bulbs
Pull the rear light unit backward (
–
) to remove the light from its housing.
2
Removing the bulb holder
Fig. 98 Light connector at the rear of the rear
light unit.
›››
Fig. 97
Retaining screws on reverse side of
Fig. 99
rear light unit.
Disconnect the light connector
–
›››
Fig. 98 by moving its side levers (arrows)
and pulling the connector outwards.
Place the light on a level, horizontal surface
–
on top of a soft cloth so as not to scratch
the outer glass.
Unscrew the four retaining screws from the
–
bulb holder anti-clockwise using a screw-
driver or a Torx 20 key (T20) from the vehi-
›››
cle tool kit Fig.
the bulb holder retaining screws.
A
99. Take care not to lose
89