Seat Toledo 2016 Owner's Manual page 120

Your vehicle does not dazzle others, partic-
●
ularly oncoming traffic
● The range of the headlights is sufficient for
safe driving
Note
Make sure you set the range of the main
lights when the dipped beam headlights are
switched on.
Daytime running lights
Daytime running lights are signalling devices
for improving road safety. The lights are built
into the headlights and come on each time
the ignition is turned on if the light switch is
›››
in position 0 or  Fig.
ically switched off when the side lights are
turned on.
Switching the daytime driving lights on
Remove the key from the ignition, move the
●
turn signal lever upward (right turn signal),
press it back to flash position and hold it
there.
● Insert the key and switch on the ignition,
holding it in this position for 3 seconds.
Then, switch off the ignition. The daytime
running light is now activated and the corre-
sponding lights can come on.
118
Switching the daytime running light off
Remove the key from the ignition, press the
●
turn signal lever down (left turn signal), press
it back to flash position and hold it here.
● Insert the key and switch on the ignition,
holding it in this position for 3 seconds.
Then, switch off the ignition. The daytime
running light is now deactivated and the cor-
responding lights cannot come on.
OR: activate and deactivate the daytime
lights using the Easy Connect system
›››

page
Automatic control of the dipped beam in
combination with the daytime running lights
If the dipped beam control and the daytime
running lights are activated at the same
129. It is automat-
time, the dipped beams and the instrument
panel lighting will automatically come on as
required (e.g. when entering a tunnel) and
the daytime running lights will switch off.
When the automatic dipped beam control
switches off the dipped beams (e.g. when
coming out of a tunnel), the daytime running
lights come back on.
WARNING
The rear lights do not come on with the day-
time driving light. A vehicle which does not
have the rear lights on may not be visible to
other drivers in the darkness, if it is raining
or in conditions of poor visibility.
Operation
21.
Note
Please observe any relevant legal require-
ments which may apply in your country.
Turn signal and main beam lever
Fig. 131 Turn signal and main beam lever.
The turn signal and main beam lever also op-
erates the parking lights and the headlight
flasher.
Right and left-hand  turn signal 
›››
Move the lever Fig. 131 up
●
.
2
Keep the lever held down at the point of re-
●
sistance for the turn signals to flash for as
long as you hold the lever, e.g. when chang-
ing lanes.
or down
1