Changing Tail Lights (On The Rear Lid) - Seat Toledo 2016 Owner's Manual

Fitting the rear light
Fit the tail light unit.
Fig. 102
Fit the tail light unit.
Fig. 103
Make sure the connector is correctly in
–
place.
1)
For rear-lid LED rear lights, only the reverse and
retro fog bulb can be replaced. The illustrations in
the manual correspond to the bulb version and do
not correspond exactly to the LED version.
Fuses and bulbs
Press the rear light unit backwards (driving
–
direction) by fitting the fastenings into the
›››
rubber mountings Fig. 102
Take the screwdriver or a Torx 20 key (T20)
–
from the vehicle tool kit and tighten (turn-
›››
Fig. 103) the two retaining
ing clockwise
screws that secure the front of the light.
Changing tail lights (on the
rear lid)
Removing the bulb holder
Remove the cover from the boot lid.
Fig. 104
.
A
1)
Fig. 105 Remove the bulb holder.
The rear lid must be open to change the
bulbs.
You can access the bulb holder for the inner
tail lights through the inside of the rear lid.
Check which of the bulbs is defective.
–
»
89