Seat Toledo 2016 Owner's Manual page 90

Pull the rear light unit backward (
–
) to remove the light from its housing.
2
Removing the bulb holder
Fig. 99 Light connector at the rear of the rear
light unit.
Retaining screws on reverse side of
Fig. 100
rear light unit.
88
Emergencies
›››
Fig. 98 Disconnect the light connector
–
›››
Fig. 99 by moving its side levers (arrows)
and pulling the connector outwards.
Place the light on a level, horizontal surface
–
on top of a soft cloth so as not to scratch
the outer glass.
Unscrew the four retaining screws from the
–
bulb holder anti-clockwise using a screw-
driver or a Torx 20 key (T20) from the vehi-
›››
cle tool kit Fig.
the bulb holder retaining screws.
Changing bulbs
Position of the bulbs in the bulb
Fig. 101
holder
The bulbs are secured with a bayonet fasten-
er. The table below gives an overview of the
bulb positions.
A –
–
–
–
100. Take care not to lose
–
–
Position of the bulbs
›››
Lightly press the defective bulb into the
bulb holder, then turn it anti-clockwise and
remove it.
Fit the new bulb, pressing it into the bulb
holder and turn it clockwise as far as it will
go.
Use a cloth to remove any fingerprints from
the glass part of the bulb.
Check that the new bulb works properly.
Replace the bulb holder.
Screw in the bulb holder using the four
screws, turning them clockwise.
Fig. 101 Bulb function
Turn signals: PY21W NA LL
A
Side lights-brake lights: P21/5W
B
Side lights: P21/5W
C
Note
Check the condition of the seal. If damaged, a
replacement can be acquired from an Official
Service.