Air Conditioning (Manual) - Seat Toledo 2016 Owner's Manual

Connecting the recirculation
In any position of rotary switch
thaw:
›››
Press button Fig. 169, the switch's
●
1
lamp will light up, indicating that air recircu-
lation inside the vehicle has been activated.
Disconnecting the recirculation
In any position of rotary switch
thaw:
● Press button again and the button's
1
lamp will go off, indicating that air recircula-
tion from the outside has been activated.
In the thaw position of rotary switch
entry of air into the vehicle interior is always
from the outside.
WARNING
Read and observe the safety warnings
General notes on page 142.

Air conditioning (manual)*

General notes
The air cooling system only works if
››› ›››
ton Fig. 170 page 145
2
and under following conditions:
● The engine is running,
● The outside temperature is above +2°C
(+36°F),
except
C
● The blower control is in position 1–4.
When the cooling system is on and under cer-
tain conditions, air can be blown from the
vents at a temperature of approximately +5°C
(+41°F). In the event of prolonged, irregular
distribution of the air flow from the outlets
and significant differences in temperature,
except
C
e.g. on leaving the vehicle, sensitive people
may catch cold.
Note
A visit to the specialised service once a year
is recommended to clean the air conditioning
, the
C
system.
Manual operation
›››
in
but-
A/C
is pressed
Air conditioning: controls.
Fig. 170
Air conditioning
Read the additional information carefully
›››

page 37
Temperature selection
›››
Turn rotary control Fig. 170
–
A
to increase the temperature.
Turn rotary control anti-clockwise to re-
–
A
duce the temperature.
Blower selection
›››
Fig. 170
Turn rotary control
– B
tion 1 to 4 to switch the blower on.
Turn rotary control to position 0 to
– B
switch the blower off.
›››
page 146, Air recir-
Press button
– 1

culation to close the fresh air vent.
Air distribution selection
›››
Turn rotary control Fig. 170
– C
›››
page 143
the air vents you wish to acti-
vate.
Switching cooling on and off
›››
Press the button Fig. 170
– A/C 2
the lamp in the button will illuminate.
Press the button again and the
– A/C 2
light in the button will switch off.
clockwise
to posi-
to select
and
»
145