Table of Contents
Advertisement
The configuration of the function is described in the installation and con-
figuration manual of the PBX.
Some providers do not transmit charge information. If a
hotel guest is using such a provider to make outbound
calls the accrued charges cannot be billed to him. Due to
this reason it is not useful to activate Soft-LCR for a hotel room tel-
ephone. To avoid manual dialling of a provider these numbers
should be added to the Blocking Numbers with COMtools tele-
Configure the Wake-up Time with the Room Telephone
b * U
4-digit entry of the time
If „0700" was entered, you would receive a wake-up call at 7
o'clock in the next morning. Consequently the wake-up time
has to be entered again for a new wake-up at the same time.
Delete the Wake-up Time with the Room Telephone
b * #
Enter the Room Status with the Room Telephone
b *
991 #
992
or
993
or
#
Special Functions for Business Applications
phone book. The Blocking Numbers have to be activated for each
hotel room telephone. Preconfigured standard files with Blocking
numbers/Released numbers have been copied to your hard disk
during the installation of COMtools. These may be imported into
the COMtools telephone book with the button „CSV import" in the
window „Blocking Numbers" or „Released Numbers". The con-
sistency of the files is not guaranteed.
After a „check out" the wake-up time is deactivated for the correspond-
ing subscriber.
Invalid entries will not delete an already valid wake-up time.
Configure a one-time Wake-up time
Delete the Wake-up time
enter room status „clean"
enter room status „uncleaned"
enter room status „blocked"
57
Advertisement
Table of Contents
