[Aux1-Epa] Aux1 End Point Adjustment; [Aux2-Epa] Aux2 End Point Adjustment - Sanwa MT-44 Manual

[AUX1-EPA] AUX1 End Point Adjustment

●You can use AUX1 for functions of accessories and adjust the maximum steering angle (operating quantity)
with EPA. Since you can set H/L separately, precise adjustment is possible.
*When setting AUX1 to [CODE5/CODE10] in AUX TYPE, the operation will not be refected even by adjusting EPA.
1) Before adjusting AUX1 End Point Adjustment (AUX1-EPA), make a neutral adjustment of the servo (P. 26).
• Neutral adjustment is to align the center position with Sub Trim by turning the power on and installing the servo
horn in the approximate center position.
2) Select [AUX1] with the Select button. Select either of [EPA- H/EPA-L]
with the multi-selector and determine with the Enter.
3) Adjust the operating quantity with the multi-selector.
○Setting range: H/L 0～150%
○Default: H/L 100%

[AUX2-EPA] AUX2 End Point Adjustment

●You can use AUX2 for functions of accessories and adjust the maximum steering angle (operating quantity)
with EPA. Since you can set H/L separately, precise adjustment is possible.
*When setting AUX2 to [CODE5/CODE10] in AUX TYPE, the operation will not be reflected even by adjusting EPA.
1) Before adjusting AUX2 End Point Adjustment (AUX2-EPA), make a neutral adjustment of the servo (P. 26).
• Neutral adjustment is to align the center position with Sub Trim by turning the power on and installing the servo
horn in the approximate center position.
2) Select [AUX2] with the Select button. Select either of [EPA-H/EPA-L]
with the multi-selector and determine with the Enter.
3) Adjust the operating quantity with the multi-selector.
○Setting range: H/L 0～150%
○Default: H/L 100%
Choose [AUX1] by select button.
Choose [AUX2] by select button.
２８