Table of Contents
Advertisement
About connection and installation of the receiver
About the receiver
●RX-471(Example)
BIND Button
About handling the Antenna
Reception distance may vary depending on the location where the receiver and
the antenna are installed.
To protect the reception part (3 cm from the top) of the antenna, make sure to
place the antenna in the antenna pipe as shown in the right illustration so that
the top of the antenna is not exposed outside of the antenna pipe.
Don't bend the antenna reception part or the antenna coaxial cable because
breaking can occur inside.
Don't pull the coaxial cable forcefully. It may damage the receiver interior.
Install the antenna on an RC car so that the antenna reception part is in as high
place as possible.
Don't cut or bind the antenna reception part or the antenna coaxial cable since
the receiver sensitivity might decrease.
Keep the receiver antenna away from the motor and the FET Speed Controller
(including cables) and raise it straight.
About built-in antenna receiver
Reception distance may vary depending on the location where the Antenn Reception part is installed.
●
Install the antenna so that the antenna reception part in the above illustration is as high as possible.
●
９
LED
BATT
CH4：4ch
CH3：3ch
CH2: Throttle
(FET Speed Controller)
CH1: Steering
Antenna Reception part
LED
BIND Button
Condition of the Receiver LED
When receiving a signal
When it cannot receive a signal
Blue light flashes.
while setting up BIND
Blue light flashes rapidly.
Battery Fail Safe Operation is launched
Blue and Red lights are on.
After Battery Fail Safe Operation is launched,
it becomes unable to receive a signal.
BATT
CH4：4ch
CH3：3ch
CH2：Throttle
(FET Speed Controller)
CH1: Steering
Blue light is on
Red light is on.
Antenna Pipe
Antenna Reception part
Antenna coaxial cable
Advertisement
Table of Contents
