Code Aux - Sanwa MT-44 Manual

CODE AUX

●Code AUX (CODE AUX) is a feature to perform code communication by assigning a setting value to each code
of CODE5 and CODE10 (CODE5/5 code, CODE10/10 code). It is an extension feature to change the setting of
speed controller (SUPER VORTEX series and SV-PLUS series) and the Gyro System (SGS-01C/SGS-01D)
that are compatible to CODE AUX.
●You can set 2 types of Code AUX1 and CODE AUX2.
*Setting of CODE is done by setting [TYPE] of [SYSTEM] menu. By setting [MODE], the display is changed
according to each equipment. When setting [MODE] to [USER], each code display allows the user to set.
*When using an AUX channel as CODE AUX, make sure to set the response mode of A1/A2 that are set for
BIND to [SHR] (See P.49, 50).
*When using CODE AUX, do not connect the servo to CH3 and CH4 of the receiver to be used.
*When using, assign the features to Dial or Trim with the Key assignments or operate with the multi-selector.
1) Select [AUX] with the multi-selector and define with the
Enter operation.
2) Setting Code AUX
Select [CODE AUX] to change setting and adjust the setting
value with the multi-selector.
○Setting range: -100～100%
○Default: 0%
*When AUX TYPE is set to CODE5/CODE10, the following is
displayed according to the setting of CODE AUX in the servo
monitor display of the top screen.
AUX TYPE = When setting is CODE AUX, bar display
CODE1 Parameter
CODE4 Parameter
CODE3 Parameter
CODE6 Parameter
+100
CODE5 Parameter
CODE9 Parameter
CODE7 Parameter
CODE8 Parameter
CODE2 Parameter
0 -100
CODE10 Parameter
AUX
ENTER BACK
When TYPE setting is [CODE10]
and MODE setting is [SV-STK]
When MODE setting is [USER]
When TYPE setting is [CODE5]
and MODE setting is [SVZ]
When MODE setting is [USER]
３６