Curve [Curve]; Steering Exponential - Sanwa MT-44 Manual

Usage of each feature

Curve [CURVE]

●Features to change the operating quantity of the servos again
wheel/throttle trigger. When the setting value is on the plus (+) side, it responds quickly,
when on the minus side (-), it responds mildly.
● You can select a curving movement exponential (EXP) and a linear movement adjustable rate control (ARC).
* When setting AUX TYPE to [CODE], adjusting the curve feature of the AUX channel does not affect
the performance. When setting curve for the AUX channel, do so using steering/ throttle as a reference.
・ Exponential (EXP)
Mild
Steering Wheel L End Operating Quantity
Throttle Trigger H End Operating Quantity
・Adjustable Rate Control (ARC)
You can change the position where operation is changeable by adjusting the setting of POINT.
Mild
Steering Wheel L End Operating Quantity
Throttle Trigger H End Operating Quantity
[ST] Steering Exponential
● You can change the steering feature from Mild to Linear to Quick. In general, if you find your RC car oversteering,
change the setting to the minus side and if you find under steering, change to the plus side.
Steering Exponential is a simultaneous setting for L and R.
1) Select ST with the Select button and
set CURVE TYPE of ST to [EXP] with the multi-selector.
2) Adjust the setting value with the multi-selector.
○Setting range: -100%～100%
○Default:
*When cancelling a selected feature, use the Back button.
２１
Quick
Normal
Quick
Normal
0%
Setting/SETTING
st operation of the steering
Quick
Normal
Steering Wheel R End Operating Quantity
Neutral Position
Throttle Trigger B End Operating Quantity
Quick
Neutral Position
Steering Wheel R End Operating Quantity
Throttle Trigger B End Operating Quantity
Steering
Operation Position
Mild
POINT
Normal
Mild