Table of Contents
Advertisement
Usage of each feature
● AUX is a feature to set the performance of AUX1 and AUX2 (3ch, 4ch). You can choose from STEP AUX (STEP),
POINT AUX (POINT), 4WS (4-Wheel Steering: Coordinate Phase, Opposite Phase). MOA (Motor On Axle), AUX-MIX
(AUX Mixing: ST à AUX/TH-AUX) and CODE5/CODE10 (Code Communication).
*Setting of AUX TYPE is done in the System Menu. Make a setting according to the purpose of the use.
STEP AUX
● Setting Step AUX allows you to set the operating quantity by operating assigned Trim or a switch.
● By factory default, the AUX feature is set to the Step AUX.
1) Select [AUX] with the multi-selector and define with the Enter
operation.
2) Setting Step AUX (STEP AUX)
Determine [CH] to activate with the Select button and set the
position of the motion with the multi-selector.
*Operating quantity can be set with EPA
(End Point Adjustment, P.27, 28).
*Assign the features to Trim and Dial with Key
Assignments according to the used method.
POINT AUX
●By setting Point AUX and assigning the movement of AUX1/AUX2 (3ch, 4ch) to the switch and Trim, you can
move the servo to the set Point.
The Point that moved can be set with EPA (End Point Adjustment).
Adjust the Point position according to the usage.
* Amount of Points will be 2 ~ 6 points and can be set with AUX TYPE.
1) Select [AUX] with the multi-selector and set with AUX TYPE.
2) Setting Point AUX (POINT AUX)
Determine [CH] to activate with the Select button and set
the Point of the motion with the multi-selector.
*Set to [POINT AUX] with (AUX TYPE) of (SYSTEM) according to
the usage.
*Assign the features to Dial and Trim with Key Assignments to
operate or operate with the multi-selector.
３３
AUX
Motion Position Display
AUX
ENTER
BACK
Secreting a Channel with the Select Button
AUX
ENTER
BACK
Advertisement
Table of Contents
