Table of Contents
Advertisement
Usage of each feature
SYSTEM MENU
CALIBRATION
●Due to wearing and tearing of the internal mechanical elements
over the usage time, the neutral position and the operation angle
might become off.
In such case, you can correct the neutral positions of the steering
and the throttle and the operation angle.
1)Select [SYSTEM] with the multi-selector and determine
with the Enter operation.
2)Select [CALIBRATION] with the multi-selector and determine
with the Enter operation.
3)Select a channel to calibrate with the multi-selector and
determine with the Enter operation.
4)When selecting [STEERING], operate the Enter with the steering
wheel in neutral, then operate the steering wheel fully to left
and right.
5)When entering the range, [OK] is displayed. Operate following
the display.
6)When calibration is done, [Executed] is displayed.
7)If the throttle side also needs calibration, refer to the steering
to set.
*Unless necessary, do not set up calibration. If the setting is
not done properly, it may not operate normally.
Supplement
●If the operation does not return to normal after calibration,
contact Sanwa Service.
５９
SYSTEM
ENTER
BACK
ENTER
BACK
ENTER
Select Yes, if it is OK.
YES Selected.
Calibration complete
Advertisement
Table of Contents
