Lap Timer - Sanwa MT-44 Manual

5) Setting START
Set the Timer Start from the Trigger Interlock/Switch/Random.
○Setting range: TRIGGER/SW/RANDOM
○Default: TRIGGER
6) Setting DATA-LOG
It sets Telemetry Data Log (record) along with the timer.
○Setting range: OFF/ON
OFF
○Default:
*Log starts along with the timer feature.

LAP TIMER

● You can measure and record each lap up to 999 laps (works for all models).
● Pre Alarm (PRE-ALM) is installed and the alarm goes off before the goal.
1) Select [TIMER] with the multi-selector and determine with the
Enter operation.
2) Starting the Timer
As a default, the timer switch is set to SW1. By holding S W1,
the timer becomes a standby state for starting and by either
pressing SW1 again or operating the throttle trigger,
measuring starts.
3) Every time you operate SW1, lap time is measured.
The switch does not work for 3 seconds after operating SW1.
4) Completing measuring
By holding SW1, measuring will be completed.
*You can check the measured lap time on the LAP TIMER screen.
When Enter is being operated while the lap timer is activa ted/
stopped on the LAP TIMER screen, the screen is changed to the
lap time display. You can check each lap time with the multi-
selector operation (not possible on the SETUP screen).
*When turning the power switch off while the timer is activated,
the timer will be reset.
*When the timer is set to SW1/SW2, the timer will be in the standby
mode by holding the switch even on a screen other than the
setting screen.
SWITCH1
Function LED
X Illumination
LED flashes while the timer is activated.
TIMER
ENTER BACK
ENTER BACK
３８