Dual Rates [D/R] - Sanwa MT-44 Manual

Usage of each feature

Dual Rates [D/R]

● You can adjust rudder angle when operating the steering wheel and throttle trigger to their peak.
To correspond to the RC car or road condition, adjust the rudder angle as you operate.
*You can adjust steering for both right and left at the same time and throttle separately for high
and brake sides. You can also adjust the brake side more precisely than adjusting with EPA.
● Donʼt increase the setting rate of dual rates (D/R) from the condition in which the linkage locks
by operating the steering wheel and throttle trigger.
● You can also adjust more precisely by adjusting dual rates of the throttle side.
*When AUX1/AUX2 are set to CODE5/CODE10, setting change of D/R will not be reflected
to the performance.
1) Select features [ST/TH (H, L)/AUX1/AUX2)
to adjust with the Select key.
2) Determine the feature to adjust with the Enter key
and adjust the setting rate with the multi-select key.
3) Adjust the valus of DUAL RATE by multi-selector.
4) During operation, the steering dual rates can be
adjusted with Trim 3, brake dual rates can be
adjusted with Trim 4. Itʼs possible to assign other
features to Trim 3 and Trim 4 with the key assign trim
feature (P. 52).
*When cancelling a selected feature,
operate the Back button.
○ Setting range: ST/TH-H/AUX1/AUX2：0％～100％
○ Default: ST/TH/AUX1/AUX2：100％
Trim 4
*Make sure that the servos do
not lock to make clicking
sound! Note)
The same for throttle.
Supplement
１９
TH-L：0%～120％
Trim 3
● Adjust the end point of the steering/throttle linkage before
adjusting dual rates (P. 27, 28).
SETTING
ENTER
DUAL RATE SETTING SCREEN
Select Channel by Multi-selector button.
ENTER
Steering Dual Rates Selection Screen
● If the linkage is locked for a long period,
Note
it can cause the servo motor breakage.
BACK
BACK
Flashing