Toshiba B-EX4 Maintenance Manual page 179

6. ON LINE MODE
RFID icon
Ribbon near end icon
ONLINE MODE DISPLAY TRANSITION, Operation example （English）
3.
Idling or normal issuing
Press [PAUSE] Key
during printing
Open head
during idling
It is used when RFID module is mounted. It is not displayed when
RFID module is not mounted.
It is ON when module is enabled and ready to communicate.
It blinks when module is communicating and processing.
- The communication includes the one not related radio wave output.
- It blinks even though radio wave is not out after instructing radio wave
output to module.
(It blinks during pausing radio wave output or changing channel by the
influence of other carrier.)
ON: Module is enabled and ready to communicate
Blinking: Communicating
The ribbon near end is detected.
It blinks when the ribbon is close to the end.
The ribbon near end is detected by diameter of remaining ribbon.
The diameter is 38 mm for 30 meter ribbon and 43 mm for 70 meter
ribbon.
Blinking: Ribbon near end condition (*4)
Stop printing when printing
Help guide is displayed
since there is
message.
Press [RIGHT] Key
Press [RESTART] Key, then resume
printing if there is remaining data
Close head
help
Help message for head open (*1)
6- 13
EO18-33027
6.3 HELP DISPLAY