Toshiba B-EX4 Maintenance Manual page 89

5. SYSTEM MODE
When the power is off, a drive time of 27 seconds or less is rounded down and backed up.
232C ERR
Counts when a parity error or a framing error occurs.
* When data of several bytes is transmitted continuously, counting is performed per byte.
SYSTEM ERR
Counts when a system error occurs.
POWER FAIL
Counts when a momentary power interruption occurs.
<< ADJUST >>
Item
[PC]FEED
CUT
BACK
TONE(T)
TONE(D)
RBN(FW)
RBN(BK)
[KEY]FEED
CUT
BACK
TONE(T)
TONE(D)
RBN(FW)
RBN(BK)
X ADJ.
THRESHOLD<R>
THRESHOLD<T>
NOTES: For B-EX4T1-G, "x.3mm" is printed as maintenance counter regardless the selection "x.2 mm" or
"x.3mm" since head resolution is 8 dots/mm. The selection of "x.7mm" and "x.8mm" is same manner.
RS-232C hardware error count
System error count
Momentary power interruption count
Content
Feed fine adjustment
Cut position (or strip position) fine
adjustment
Back feed fine adjustment
Print density fine adjustment
(Thermal transfer print mode)
Print density fine adjustment
(Direct thermal print mode)
Ribbon motor drive voltage fine
adjustment (Rewind)
Ribbon motor drive voltage fine
adjustment (Back tension)
Feed fine adjustment
Cut position (or strip position) fine
adjustment
Back feed fine adjustment
Print density fine adjustment
(Thermal transfer print mode)
Print density fine adjustment
(Direct thermal print mode)
Ribbon motor drive voltage fine
adjustment (Rewind)
Ribbon motor drive voltage fine
adjustment (Back tension)
X-coordinate fine adjustment
Reflective sensor manual threshold
fine adjustment
Transmissive sensor manual
threshold fine adjustment
5-7
5.3 SELF-DIAGNOSTIC TEST
0 ∼ 255
0 ∼ 15
0 ∼ 15
Remark
-50.0mm ∼ +50.0mm (*1)
-50.0mm ∼ +50.0mm (*1)
-9.9mm ∼ +9.9mm (*1)
-10 ∼ +10step
-10 ∼ +10step
-15 ∼ +10step
-15 ∼ +10step
-50.0mm ∼ +50.0mm
-50.0mm ∼ +50.0mm
-9.5mm ∼ +9.5mm
-20 ∼ +10step
-20 ∼ +10step
-15 ∼ +10step
-15 ∼ +10step
-99.5mm ∼ +99.5mm
0.0V ∼ 4.0V
0.0V ∼ 4.0V
EO18-33027