Page 1
! 0 0 T S C C 0 3 3 5 8 0 1 ! TOSHIBA BARCODE PRINTER B-EX6T Series Quick Installation Manual This manual is a quick guide on how to set up your B-EX6T printer. For more details please read the Owner’s manual in the CDROM.
Power cord NOTES: 1. Check for damages or scratches on the printer. However, please note that TOSHIBA TEC shall have no liability for any damage of any kind sustained during transportation of the product. 2. Keep the carton and internal packaging for future transportation of the printer.
Page 3
3. Loading the Supplies WARNING! 1. Do not touch any moving parts. To reduce the risk of fingers, jewellery, clothing, etc., being drawn into the moving parts, be sure to load the media once the printer has stopped moving completely. 2.
Page 4
Position Position2:Labels Position Position1: Tags However, proper position may differ depending on media. For details, refer to your TOSHIBA TEC authorised service representative. 3. Do not turn the Locking Ring counter-clockwise too far or it may come off the Supply Holder.
Page 5
In the case of labels rolled with In the case of labels rolled with the print side facing inside. the print side facing outside. Guide Shaft Media 8. Place the media between the Media Guides, adjust the Media Guides to the media width, and tighten the Locking Screw.
Page 6
Loading with peel off module When the optional Peel-off Module is fitted, the backing paper is automatically removed from the label at the Strip Plate as each label is printed. (1) Remove enough labels from the leading edge of the media to leave 500mm of backing paper free.
3.2 Loading the Ribbon There are two types of media available for printing on: these are thermal transfer media and direct thermal media (a chemically treated surface). DO NOT LOAD a ribbon when using a direct thermal media. 1. Grasp the tabs on the top and bottom of the Ribbon Stoppers and move the Ribbon Stoppers back to the end of the Ribbon Shaft.