Toshiba B-EX4 Maintenance Manual page 39

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
9. Pull out the Strip Sensor Harness from the opposite side, and pass it through the Cable Protector.
Strip Sensor Harness
10. Fasten the Strip Sensor Harness with the Cable Clamp.
11 Connect the Strip Sensor Harness and Rewind Full Sensor Harness to the Rewinder Harness.
Main PC Board
Rewinder
Harness
Rewind Full
Sensor Harness
3-pin Connector of the
Rewinder Harness
12. Close the Print Head Block and Ribbon Shaft Holder Plate.
NOTE: DO NOT excessively push down the print head block to close it. Doing so may cause a failure of
the print head block or damage to the print head.
13. Re-install the Side Panel (L).
14. Set the selection switch mounted on the Rewinder Ass'y to STANDARD/PEEL OFF position.
4-pin Connector of the
Rewinder Harness
Rewinder Ass'y
Strip Sensor Harness
4-24
(Revision Date: Aug. 24, 2011)
4.3 PEEL-OFF MODULE (B-EX904-H-QM-R)
Cable Protector
Cable Clamp
EO18-33027