5. SYSTEM MODE
5.6.6
White line print / NON-PRINTING
The printer feed white paper.
5.6.7
Factory test / FACTORY TEST
5.6.8
Auto print (Transmissive) / AUTO PRINT (TRANS.)
The test print for manufacturing is started by the following conditions. The parameter setting content
and print density fine adjustment value are ignored.
The following test print is started by press any key except [CANCEL] key after each printing.
When [CANCEL] key is pressed, return to menu.
Movement contents
Issue piece5 pieces each
Print speed
Sensor type
Print method
Issue type
Label pitch
Print density fine adjustment value
1 piece paper feed
3-dot slan line print
Barcode print
Character print
5 pieces each
203dpi:6"/sec
305dpi:5"/sec
Transmissive sensor
Thermal transfer
Continuous issue
76mm
±0
5-53
EO18-33027
5.6 TEST PRINT