Toshiba B-EX4 Maintenance Manual page 37

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
13. Connect the Rewinder Harness to J11 on the Main PC board.
14. Connect the Rewind Full Sensor Harness to the 3-pin connector of the Rewinder Harness.
Rewinder Harness
15. When the printer is used in the strip mode, where the printed label is peeled one by one, go to Section
4.3.3 Installing the Strip Sensors.
When the printer is used in the Rewinder mode, where the printed media is taken up into a roll, go to
Section 4.3.4 Attaching the Rewinder Guide Plate.
4.3.3 Installing the Strip Sensors
1. Turn the head lever counterclockwise to FREE position.
2. Open the ribbon shaft holder plate.
Head Lever
3. Raise the print head block until it stops.
Print Head Block
Main PC Board
Head Lever
J11
4-22
(Revision Date: Aug. 24, 2011)
4.3 PEEL-OFF MODULE (B-EX904-H-QM-R)
Ribbon Shaft
Holder Plate
EO18-33027