Toshiba B-EX4 Maintenance Manual page 123

B-ex4 series
Hide thumbs Also See for B-EX4:
Table of Contents

Advertisement

5. SYSTEM MODE
[Procedure for label having less than the min. label pitch for each issue speed when the rotary cutter
is used]
When the following conditions are all met, the cut operation for the last label to be cut is as follows.
Forward feed to the cut position → Cut with feeding → Feed stops →
Head lifted → Reverse feed to the home position → Head lowered
Conditions: Issue Command, Feed Command, and Eject Command received.
Label pitch: Less than the min. label pitch for each issue speed,
cut performed, transmissive sensor designated, cut position fine adjustment
of ±10.0 mm or less, and issue mode "C"
* For the Issue Command, this procedure is effective only for the last label to be cut
when the next Issue Command is not received.
* The head is lifted/lowered only when the optional ribbon save module is attached and
the ribbon saving system is set to ON in the parameter setting. When the ribbon save
module is not installed, the head-up/down operations are not performed.
"NOTES" below.
NOTES: 1. If the head is being lifted up when the edge of the label which is being
ejected passes the paper feed roller, the sensor may not be able to
detect an error even if it occurs (a feed cannot be performed more).
2. If the head-up solenoid temperature is high when a cut issue is about to
be performed with the head lifted, the head may not be lifted.
5.5 PRINTER PARAMETER FINE ADJUSTMENT
5-41
EO18-33027
See

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents