Toshiba B-EX4 Maintenance Manual page 29

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
4.2.4 Wiring of the Harness Ass'y
1. Pass the Harness Ass'y through the Cable Protector.
2. Fasten the Harness Ass'y with the Cable Clamp.
3. Connect the Harness Ass'y to J11 on the Main PC board.
Main PC Board
Harness Ass'y
4. Close the Print Head Block and Ribbon Shaft Holder Plate.
NOTE: DO NOT excessively push down the print head block to close it. Doing so may cause a failure of
the print head block or damage to the print head.
5. Re-install the Side Panel (L) and close the Top Cover
6. Refer to the Service Manual for the parameter settings and check the cutter operation.
Cable Protector
J11
Cable Clamp
4-14
(Revision Date: Aug. 24, 2001)
4.2 ROTARY CUTTER (B-EX204-R-QM-R)
Harness Ass'y
Cable Clamp
Harness Ass'y
EO18-33027