STMicroelectronics STM32F050G6 Manual page 42

Electrical characteristics
Typical and maximum current consumption
The MCU is placed under the following conditions:
●
All I/O pins are in input mode with a static value at V
●
All peripherals are disabled except when explicitly mentioned
●
The Flash memory access time is adjusted to the f
to 24 MHz and 1 wait state above 24 MHz)
●
Prefetch is ON when the peripherals are enabled, otherwise it is OFF (to enable
prefetch the PRFTBE bit in the FLASH_ACR register must be set before clock setting
and bus prescaling)
●
When the peripherals are enabled f
The parameters given in
ambient temperature and supply voltage conditions summarized in
42/98
= f
PCLK
Table 23 to Table 24 are derived from tests performed under
Doc ID 023079 Rev 3
or V (no load)
DD SS
frequency (0 wait state from 0
HCLK
HCLK
Table
STM32F050xx
15.