Table 13 - STMicroelectronics STM32F050G6 Manual

Electrical characteristics

Table 13.

Symbol
I
VDD
I
VSS
I
I
INJ(PIN)
I
INJ(PIN)
1. All main power (V
supply, in the permitted range.
2. Positive injection is not possible on these I/Os and does not occur for input voltages lower than the
specified maximum value.
3. A positive injection is induced by V
never be exceeded. Refer also to
values.
4. A positive injection is induced by V
never be exceeded. Refer also to
values. Negative injection disturbs the analog performance of the device. See note 2 below
page 72.
5. When several inputs are submitted to a current injection, the maximum I
positive and negative injected currents (instantaneous values).
Table 14.
Symbol
T
STG
T
38/98
Current characteristics
Total current into V
Total current out of V
Output current sunk by any I/O and control pin
IO
Output current source by any I/Os and control pin
Injected current on FT, FTf and B pins
Injected current on TC and RST pin
Injected current on TTa pins
Total injected current (sum of all I/O and control
(5)
pins)
, V ) and ground (V
DD DDA
Thermal characteristics
Storage temperature range
Maximum junction temperature
J
Doc ID 023079 Rev 3
Ratings
power lines (source)
DD
ground lines (sink)
SS
, V ) pins must always be connected to the external power
SS SSA
>V while a negative injection is induced by V
IN DD
Table 12: Voltage characteristics
>V while a negative injection is induced by V
IN DDA
Table 12: Voltage characteristics
Ratings
STM32F050xx
Max.
(1)
100
(1)
100
25
 25
(2)
-5
(3)
± 5
(4)
± 5
± 25
<V . I
IN SS INJ(PIN)
for the maximum allowed input voltage
<V . I
IN SS INJ(PIN)
for the maximum allowed input voltage
Table 51 on
is the absolute sum of the
INJ(PIN)
Value
–65 to +150
150
Unit
mA
must
must
Unit
°C
°C