STMicroelectronics STM32L162RC Manual page 118

Revision History
Date
06-Feb-2013
19-Jul-2013
118/123
Table 72. Document revision history (continued)
Revision
Removed AHB1/AHB2 and corrected typo on APB1/APB2 in
Ultra-low-power STM32L162xC block diagram
Updated "OP amp" line in
working mode (from Run/active down to standby)
Added IWDG and WWDG rows in
on the working mode (from Run/active down to standby)
Updated address range in
measured values
The comment "HSE = 16 MHz(2) (PLL ON for fHCLK above 16 MHz)"
replaced by "fHSE = fHCLK up to 16 MHz included, fHSE = fHCLK/2
3
above 16 MHz (PLL ON)(2)" in table
Sleep mode
Updated Stop mode current to
Replaced BGA132 by UFBGA132 in
UFBGA132 ballout.
Updated entire
Updated Figure 25: Typical connection diagram using the ADC
definition of symbol "R
Removed first sentence in
Removed STM32L162QC and STM32L162ZC part numbers including
all associated features.
Updated dThreshold/dt conditions in
characteristics.
Updated Figure 8: Power supply
Updated Figure 34: Thermal
Updated PH0-OSC_IN and PH1-OSC_OUT type in
STM32L162xC pin
4
Added Section 6.1.7: Optional LCD power supply
Updated I
DD
maximum current consumptions in Standby
Updated Figure 6: Pin loading
Updated Figure 7: Pin input
Updated Figure 14: Typical application with a 32.768 kHz
Updated Figure 16: Recommended NRST pin
Updated Figure 17: I2C bus AC waveforms and measurement
DocID022881 Rev 10
STM32L162VC, STM32L162RC
Changes
Table 4: Functionalities depending on the
Table 4: Functionalities depending
Table 7: Internal voltage reference
Table 19: Current consumption in
1.5 µA
Section 7: Package characteristics
" in Table 55: ADC characteristics
AIN
Section : I2C interface characteristics
scheme.
resistance.
definitions.
(WU from Standby) unit in
conditions.
voltage.
in Ultra-low-power platform
Figure 4: STM32L162QC
Table 62: Comparator 2
Figure 9:
scheme.
Table 23: Typical and
mode.
crystal.
protection.
Figure 1:
and
circuit.