Connecting External I/O Signal Cable; Connecting External Input Signal Cable - Toshiba TS2000 Instruction Manual

4.

Connecting External I/O Signal Cable

4.1

Connecting External Input Signal Cable

To connect the external input signal cable, use the attached connector [XM2D–3701
(socket type connector), XM2S–3711 (connector cover)].
The input common comes in the two (2) types; Type N [X8HN (output sink type) is
selected for the I/O printed board and the polarity is the same as in the SR7000
robot] and Type P [X8HI (output source type) is selected for the I/O printed board).
After confirming the type of your controller, connect the external input signal cables.
– 26 –
INTERFACE MANUAL
STE 71367