Attaching And Detaching Ext-I/O Cable - Toshiba TS2000 Instruction Manual

Robot controller
Hide thumbs Also See for TS2000:
Table of Contents

Advertisement

7.3
Attaching and Detaching EXT–I/O Cable
For the EXT–I/O cable, use the cable attached to the TR48DIOCN/TR48DIOC
module, or a cable which meets the specifications.
Before attaching or detaching the EXT–I/O cable to or from the TS2000/TS2100
robot controller, be sure to turn off the POWER switch equipped on the rear side of
the controller, or the main power in the user's control panel.
Twisted cable: 0.14 ~ 1 mm dia.
(Stripped length 10 mm)
While holding the control lever with a screwdriver, push the
twisted cable, then remove the lever from the control lever.
Fig. 7.5 Attaching and detaching EXT–I/O cable
As shown in Fig. 7.5 above, when connecting the EXT–I/O cable, keep holding the
spring type control lever above the connector with a screwdriver and completely
push the attached cable. Remove the screwdriver from the control lever then.
(Lightly pull the cable and make sure that the cable is connected completely and will
not come off. DO NOT pull the cable by force, however. If an unusually large
force is exerted on the cable, the cable may be damaged.)
To detach the cable, hold the control lever with the screwdriver, draw out the cable
and remove the screwdriver.
Spring type control lever
Screwdriver
– 97 –
INTERFACE MANUAL
STE 71367

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ts2100

Table of Contents