Cessna 182S Pilot Operating Handbook page 355

SECTION 9 - SUPPLEMENTS
SUPPLEMENT 15 - FAA APPROVED
CESSNA
MODEL 182S
I
I
I
S15-20B
NOTE
If red
~
light is not observed after holding RH
switch for 5 seconds, the trim monitor system has
failed . The flight may be continued if the AUTO
PILOT circuit breaker is pulled to the OFF position
until repairs can be made.
D. RH SWITCH -- PULL AFT to UP position and hold for 5
seconds. OBSERVE NO MOVEMENT of Elevator Trim
wheel. Verify red
~
light above AP button. Release
switch to center OFF position.
E. LH and RH Switches PUSH FORWARD
SIMULTANEOUSLY and HOLD. OBSERVE
MOVEMENT of Elevator Trim wheel in proper direction
(nose down). While holding LH and RH switches
forward, PRESS and HOLD AlP DISCfTRIM INT switch.
OBSERVE NO MOVEMENT of Elevator Trim wheel.
Continue to hold LH and RH switches forward and
RELEASE AlP DISCfTRIM INT switch. OBSERVE
MOVEMENT of Elevator Trim wheel in proper direction.
Re lease LH and RH switches to center OFF position.
NOTE
During steps E. and F., verify movement of elevator
trim tab in proper direction (the elevator trim tab will
move up for nose down trim) . If movement of
Elevator Trim wheel is observed while the AlP
DISCfTRIM INT switch is pressed, the manual
electric trim system has failed. The flight may be
continued if the AUTO PILOT circuit breaker is
pulled to the OFF position until repairs can be made.
F. LH and RH Switches -- PUSH AFT SIMULTANEOUSLY
and HOLD. OBSERVE MOVEMENT of Elevator Trim
wheel in proper direction (nose up). While holding LH
and RH switches aft, PRESS and HOLD AlP DISCfTRIM
INT switch. OBSERVE NO MOVEMENT of Elevator
Trim wheel. Continue to hold LH and RH switches aft
and RELEASE AlP DISCfTRIM INT switch. OBSERVE
MOVEMENT of Elevator Trim wheel in proper direction.
Release LH and RH switches to center OFF position.
Revision 3