Cessna 182S Pilot Operating Handbook page 248

CESSNA
MODEL 182S
SECTION 9 - SUPPLEMENTS
SUPPLEMENT 1 - FAA APPROVED
1. OPERATING COMM FREQUENCY DISPLAY -- Displays
COMM ACTIVE and COMM STANDBY frequencies with a "T"
between them to indicate TRANSMIT and an "R" to indicate
RECEIVE modes of operation.
2. OPERATING NAV FREQUENCY DISPLAY -- The right
portion of the display is allocated to NAV receiver ACTIVE and
STANDBY information. The frequency channeling is similar to
the COMM when operating in the frequency mode. The NAV
ACTIVE and STANDBY frequencies are stored in the memory
on power down and return on power up.
3. NAV STANDBY/OBS/Bearing/RadialfTimer Display -- The right
side of the NAV display is controlled by the MODE
SELECTOR BUDON (see #7 below). With an active VOR
frequency, this portion of the display shows the STANDBY
frequency, OBS setting for the internal CDI, the bearing to the
VOR station, radial from the VOR station , or a count-up/count-
down timer. With an active localizer frequency, this portion of
the display shows the standby frequency, the letters "LOC", or
count-up/count-down timer.
4. NAV FREQUENCY SELECTOR KNOB (SMALL) -- Operates
in 50 kHz steps. The NAV receiver's lower and upper
frequency limits are 108.00 MHz and 117.95 MHz. Exceeding
the upper limit of frequency band will automatically return to
the lower limit and vice versa. A clockwise rotation will
increase (inc) the previous frequency while a counterclockwise
rotation will decrease (dec) the previous frequency.
5. NAV FREQUENCY SELECTOR KNOB (LARGE) -- Operates
in 1 MHz steps. The frequency inc/dec operates the
STANDBY frequency display. A clockwise rotation will
increase the previous frequency while a counterclockwise
rotation ' will decrease the previous frequency. Exceeding the
upper limit of the frequency band will automatically return to
the lower limit and vice versa.
Figure 1. Bendix/King KX 155A VHF NAV/COMM with KI 208 or KI
209A Indicator Head (Sheet 3 of 7)
/ 7
1-