Running Belt And Deck Cleaning Procedure - Precor TRM700-16 Base Service Manual

Perform the following maintenance tasks every 6 months:
Semiannual Task
Clean and lubricate the Lift Motor
jackscrew.

Running Belt and Deck Cleaning Procedure

Review the entire procedure before beginning.
1. Verify the proper operation of the safety Stop key.
a. Stand to one side of the treadmill – Do not stand or allow others to stand on the
treadmill running belt during this procedure. Ensure that the stop key tether is
hanging straight down and is not wrapped around the handle bars.
b. Select Quick Start and wait for the running belt to begin moving
c. When the running belt is moving, push the SAFETY STOP key.
d. Ensure the running belt stops moving, then reset the SAFETY STOP key.
e. Turn the power switch to OFF. The ON/OFF switch is located at the front of the
treadmill.
WARNING: If the running belt does not stop, turn off the power using the ON/OFF
switch at the front of the treadmill and
remain out of service until the stop switch is repaired.
2. Get a clean, dry cotton towel that is at least 36 inches (1 meter) in length and fold it in
half lengthwise.
a. Lift the running belt and push the towel through to the other side so that both ends
of the towel extend an equal distance over the deck trim on both sides.
b. Push the towel forward to the front of the machine so it is located beneath the
SAFETY STOP key.
c. Turn the power switch to ON.
3. Stand on the machine straddling the running belt placing your feet on the left and right
trim landings. Attach the stop key tether clip. Do not stand on the running belt at any
time. Stand firmly on both ends of the towel keeping your feet off the treadmill running
belt. Brace yourself using the handlebars or side hand rails. Push the Quick Start but-
ton once in position.
1
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
Experience Series 700 Line Treadmills
Running Belt and Deck Cleaning Procedure
Instruction
Raise the Incline to maximum, Switch the input
power OFF, and unplug the power cord. Clean
the jackscrew and apply approved grease, see
"General Information" on
1
unplug the power cord. The treadmill must
7 Preventative Maintenance
page 3.
156