Precor TRM700-16 Base Service Manual page 107

TIP: Use (turn) the Drive Motor flywheel to make it easier to turn the motor pulley and
help walk the belt onto or off the Drive Motor and Drive Roller pulleys.
4. Reinstall the left side Dust Guard #3 Phillips fastener and fully tighten.
5. Make sure the Drive Belt pulley alignment is correct and then tension the Drive Belt to
specification. see
6. Connect the power cord and switch the power ON.
7. Operate the treadmill and verify the running belt tracking, see
and Tracking Adjustment" on
8. Reinstall the left and right trim landing covers, see
on page 59.
9. Reinstall the hood cover, see
10. Do the Operation Verification tests (see
to service.
Experience Series 700 Line Treadmills
"Drive Belt Tension and Alignment Adjustment" on
page 40.
"Covers and Panels Replacement" on
"Trim Landing Covers Replacement"
"Operation Verification" on
5 Replacement Procedures
Drive Belt Replacement
page 36.
"Running Belt Tension
page 54.
page 15) and return
100