Replacement Procedure - Precor TRM700-16 Base Service Manual

Replacement Procedure

Review entire procedure before starting.
Removal Instructions
1. Switch the power OFF and
2. Remove the hood cover, see
3. Facing the front of the treadmill, remove the two right side 5/16" hex fasteners and then
loosen the two left side 5/16" hex fasteners (approx, 4 full turns). Slide the MC base to
the right to remove. Retain fastener hardware for installation.
4. Carefully raise front and rear of MC as needed to disconnect the attached
cable connectors, see
Note: The COMM connector contacts have an application of dielectric grease
to ensure proper electrical contact. Do not wipe off, clean, or remove the dielec-
tric grease.
Installation Instructions
1. Place the MC into the drive motor compartment and reconnect the removed MC I/O
cable connectors. It will be easier to attach the connectors before installing the MC into
1
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
2
Input and Output Interface.
Experience Series 700 Line Treadmills
1
unplug the power cord.
"Hood Cover Replacement" on
."Motor Controller (MC) Replacement" on page 84
5 Replacement Procedures
Motor Controller (MC) Replacement
page 56.
2
I/O
.
interface
92