Precor TRM700-16 Base Service Manual page 130

access" on page 49
Note: You can also access the jackscrew by laying the treadmill on its side, see
lift platform assembly access" on page 49
3. Access the service menu (51765761) and select INCLINE TEST. Use the incline con-
trol to set the incline level to 14.
4. Securely and safely place supports (e.g. car jack stands) under the left and right front
corners of the frame weldment.
5. Slowly lower the incline level in 0.5 increments until the complete weight of the frame is
setting on the supports. Verify the supports are stable and secure carrying the weight of
the treadmill. Continue lowering the incline level to "0". Incline level "0" is the lift motor
calibration reference incline level.
IMPORTANT: Its important to set the incline level to "0" (calibration ref level) before
switching the power OFF.
6. Switch the power OFF and
7. Disconnect the lift motor interface cable from the
interface cable from the cable routing clamp.
1
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
2
Motor Controller Module
Experience Series 700 Line Treadmills
procedure.
1
unplug the power cord.
5 Replacement Procedures
procedure.
2
MC "LIFT" connector. Remove the
Lift Motor Replacement
"Side
123