Precor TRM700-16 Base Service Manual page 51

1. Connect the power cord and switch the power ON.
2. Start the treadmill and set the speed to 3 mph (5 kph).
3. Observe and verify that the running belt tracking remains centered, if the belt does not
remain centered, follow the following instruction to make adjustments:
a. If the belt starts to drift toward the right, slowly turn the right side tension adjust-
ment bolt clockwise in ¼ turn increments until the drifting stops.
b. If the belt starts to drift toward the left, slowly turn the right side tension adjust-
ment bolt counterclockwise in ¼ turn increments until the drifting stops.
4. Increase the speed to 6 mph (10 Kph) verify tracking, then increase the speed to 9 mph
(14 kph) verify tracking, and finally increase the speed to 12 mph (19 kph) and verify
tracking. Make sure that the tracking remains centered at each speed, make small
adjustments as needed.
5. Make sure that the treadmill is setting level and stable, adjust the two rear leveling feet
as necessary.
Note: An unlevel unstable treadmill can cause tracking issues with use.
6. Replace the hood and left/right trim landing covers, see
ment" on page 54.
7. Verify treadmill operation (see
vice.
Experience Series 700 Line Treadmills
Running Belt Tension and Tracking Adjustment
"Operation Verification" on
4 Adjustment Procedures
"Covers and Panels Replace-
page 15) and return to ser-
44