Precor TRM700-16 Base Service Manual page 68

1. Install by sliding the cover over the landing trim mounting clips from the back towards
the front while pressing down on the cover top. Continue the process until all the landing
mount clips lock in place.
2. Press down on the top of the cover at the rear (see figure lift point) to lock the rear cover
tab clip in place.
3. Secure the rear tab clip by fully tightening the #2 Phillips keeper block fastener.
4. Secure the front of the trim landing cover using the #3 Phillips screw, washer, and bush-
ing fastener hardware. Fully tighten the fastener.
5. Repeat installation procedure for both the left
6. Reinstall the hood cover, see
Experience Series 700 Line Treadmills
and right
"Hood Cover Replacement" on
5 Replacement Procedures
Covers and Panels Replacement
trim landing covers.
page 56.
61