Precor TRM700-16 Base Service Manual page 150

Removing Error Event Codes:
To remove an error code, select the error code to be removed and press/hold the QUICK
START key for a minimum of 6 secs until the ."NO ERRORS" message shows.
TIP: Error Log Delete Short Cut:
Press and hold the PAUSE/RESET key for a minimum of 6 seconds to open the Error
Log and view all logged error codes. If there are no logged error codes, the "Stuck
Key" message will show. To remove error codes, select the error code and press/hold
the QUICK START key until the "NO ERRORS" message shows.
CPA Event Log (P62, P80, and P82)
Each logged machine error code will be shown on the CPA Event Log menu. Use the touch-
screen vertical scrollbar to scroll up/down thru the list of error codes.
The P62, P80, and P82 CPA Event Log provides the same error code data found in the P10,
P20, and P30 Error Log in addition to the event date & time stamp information. Tne "CPA
ERROR" identifier in the error code output message indicates that this is a machine fault error
code that can be used along with the Error Code Troubleshooting Guide to help resolve the
issue.
Typical CPA Event Log data:
Error Code Data
l
Event Time & Date Stamp
o
Error Code
o
Error Code
o
Odometer
o
Hours
o
Motor Current*
o
.Input Line Current*
o
Input line voltage*
o
Buss Voltage*
o
OEM Factory only data
o
* machine dependent parameter.
Removing Error Codes:
Experience Series 700 Line Treadmills
Number
Description
6 Troubleshooting
143