Monthly Maintenance - Precor TRM700-16 Base Service Manual

Weekly Task
‡
Power OFF .
Verify that the power cord is
‡
not damaged .
Vacuum and clean floor area
underneath equipment
Power ON.
Verify unit sits level and solid
on floor
Verify console and machine
operation including the Heart
Rate feature:
‡
Note: Perform task with power removed and incline set to maximum level.

Monthly Maintenance

Perform the Daily and Weekly task in addition to the following monthly maintenance tasks.
WARNING: DANGER USE EXTREME CAUTION when the rear cover of any
TRM is removed. Serious injury could result if fingers are pinched between the fly-
wheel spokes, cranks, movable arms, and the drive weldment. Securing the mov-
able arm to the crank with a clamp is recommended. Be aware of other people
within your work area who might cause the arm to move.
Monthly Task
Do the Daily and Weekly
maintenance tasks
Verify the Safety clip is
attached to the lanyard
and functional.
Visually inspect the run-
ning belt and deck con-
dition.
Clean Drive Motor and pul-
1
leys .
1
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
Experience Series 700 Line Treadmills
Raise the Incline to maximum level and then switch the
input power OFF and
Perform the following tasks with the power switch OFF,
and power cord disconnectged:
Verify that the power cord is not damaged, pinched,
coiled, or positioned under the machine
Vacuum and use damp mop to clean floor area under-
.
neath equipment. Make sure the floor is completely dry
when finished
Restore power to the machine. Connect the power cord
and switch power ON for the remaining tasks. For Incline
models, reset incline level to 0%.
Use a bubble level placed on running belt to verify level.
All feet should be touching the floor and the unit should
not rock or wobble when in use.
Perform the Operation Verification procedure to verify
console and machine operation, see
fication Tests." on
Do the Daily and Weekly maintenance tasks in addition to
the following monthly maintenance tasks.
Pull on the lanyard attached to the Safety clip which trips the
Restart (Stop/Restart) switch. The "PUSH TO RESET
SWITCH" message is shown and an arrow pointing to the
Restart switch. treadmill slows and stops.
Make sure the deck and belt are in good condition, replace
as necessary.
Remove hood and use wire brush to clean belt and pulley
grooves.
7 Preventative Maintenance
Description
1
unplug the power cord:
‡
page 15.
Instruction
Maintenance Schedule
‡
.
"Operation Veri-
154