Running Belt And Deck Cleaning Procedure - Precor TRM 885.v2 Service Manual

Running Belt and Deck Cleaning Procedure

Review the entire procedure before beginning.
1. First, check for proper operation of the safety Stop key.
a. Stand to one side of the treadmill – Do not stand or allow others to stand on the
treadmill running belt during this procedure. Ensure that the stop key tether is hanging
straight down and is not wrapped around the handle bars.
b. Select Quick Start and wait for the running belt to begin moving
c. Once the running belt is moving, push the SAFETY STOP key.
d. Ensure the running belt stops moving, then reset the SAFETY STOP key.
e. Turn the power switch to OFF. The ON/OFF switch is located at the front of the
treadmill.
WARNING: If the running belt does not stop, turn off the power using the ON/OFF
switch at the front of the treadmill and unplug the power cord. The treadmill must
remain out of service until the stop switch is repaired.
2. Get a clean, dry cotton towel that is at least 36 inches (1 meter) in length and fold it in half
lengthwise.
a. Lift the running belt and push the towel through to the other side so that both ends of
the towel extend an equal distance over the deck trim on both sides.
b. Push the towel forward to the front of the machine so it is located beneath the SAFETY
STOP key.
c. Turn the power switch to ON.
3. Mount the machine by standing on the side rails and attach the stop key tether. Do not stand
on the running belt at any time. Stand firmly on both ends of the towel keeping your feet off of
the treadmill running belt. Brace yourself using the handlebars or side hand rails. Push the
Quick Start button once in position.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 99