Precor TRM700-16 Base Service Manual page 88

ID
Power Entry Assembly Bracket
Power Cord Inlet Assembly
ON/OFF SW Circuit Breaker
ASL PCA
ASL PCA Bracket
Removal Instructions
1. Switch the power OFF and
TIP:For easier access, raise the incline to maximum before removing power. Access
the service Hardware Validation (51765761) and use the CROSSRAMP/INCLINE
Test to raise the incline and then remove power.
2. Remove the hood cover, see
3. Remove the four #3 Phillips fasteners and remove the Power Entry Assembly bracket
. Hold the bracket while removing to prevent wire cable damage. Retain fastener
hardware for installation.
4. Disconnect the ASL interface cable RJ11 connector, see
5. Remove the ASL PCA Bracket
tom (underside) of the Power Entry Assembly Bracket
6. Unsnap the ASL PCA
1
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
Experience Series 700 Line Treadmills
Description
1
unplug the power cord.
"Hood Cover Replacement" on
by pressing the inner and outer tab clips on the bot-
board from the ASL PCA Bracket
5 Replacement Procedures
ASL PCA Replacement
page 56.
"Wire Diagram" on page 79.
while lifting the ASL bracket.
by pressing the outer
81