Treadmill Deck And Running Belt Cleaning - Precor Energy Series Service Manual

Treadmill Deck and Running Belt Cleaning

Clean the belt on a Monthly basis or as.
1. Verify the proper operation of the safety Stop key. Stand to one side of the treadmill – Do not
stand or allow others to stand on the treadmill running belt during this procedure. Ensure that
the stop key tether is hanging straight down and is not wrapped around the handle bars.
a. Select Quick Start and wait for the running belt to begin moving
b. When the running belt is moving, push the SAFETY STOP key.
c. Ensure the running belt stops moving, then reset the SAFETY STOP key.
d. Turn the power switch to OFF. The ON/OFF switch is located at the front of the
treadmill.
WARNING: If the running belt does not stop, turn off the power using the ON/OFF switch at the front
of the treadmill and unplug the power cord. The treadmill must remain out of service until the stop
switch is repaired.
2. Get a clean, dry cotton towel that is at least 36 inches (1 meter) in length and fold it in half
lengthwise.
a. Lift the running belt and push the towel through to the other side so that both ends of
the towel extend an equal distance over the deck trim on both sides.
b. Push the towel forward to the front of the machine so it is located beneath the
SAFETY STOP key.
c. Turn the power switch to ON.
3. Stand on the machine straddling the running belt placing your feet on the left and right trim
landings. Attach the stop key tether clip. Do not stand on the running belt at any time. Stand
firmly on both ends of the towel keeping your feet off the treadmill running belt. Brace
yourself using the handlebars or side hand rails. Push the Quick Start button once in
position.
© 2014 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Page 47 of 56