Precor TRM700-16 Base Service Manual page 29

DIAGNOSTIC
TEST
KEYBOARD TEST
PVS KEY TEST
HEART RATE
ACTIVE STATUS
LIGHT
AS LIGHT
BRIGHTNESS
2
MC LIGHT
BELT SPEED
TEST
AUTO STOP TEST
INCLINE TEST
1
Active Status Light: Service and maintenance status light.
2
Motor Controller Module
Experience Series 700 Line Treadmills
group of LEDs and verify that all LEDs illuminate. Press Back to exit the
test.
An illuminated LED map of the function keys will be shown. Press each indi-
vidual key and verify that the corresponding LED extinguishes. Press and
hold BACK to exit the test.
Not used, OEM test.
Tests the unfiltered, filtered, and pulse heart rate. Grasp the grips to test the
hand held heart rate. Use a Polar heart rate simulator to test the wireless
heart rate. Press the BACK button to exit this test.
1
The current ASL status light state (blue. pulsing blue, yellow, & pulsing yel-
low).
Sets the ASL light brightness level and ON/OFF state: HIGH. MED, LOW,
and ON/OFF.
Shows current state of MC LED-Hold Quick Start to reset.
Menu path: MACHINE TEST > BELT SPEED TEST
Tests belt operating condition in 0.1 speed increments
Test parameters:
• AMPS IN: Treadmill input Current.
• VOLTS IN: Treadmill input Voltage
• VBUSS: Treadmill internal buss Voltage
• AMPS MTR: Current supplied to the drive motor.
Menu path: MACHINE TEST > AUTO STOP TEST
Test parameters;
• Status - User detected on running belt (detected/not detected)
• Step Count - Average # of footplants. Footplant averaging delay reset with
each speed change.
.
Menu path: MACHINE TEST > INCLINE TEST
Test parameters;
• A/D - lift motor incline position potentiometer A/D number.
Hardware Validation Service Mode (51765761)
TEST DESCRIPTION
3 Standard Service Modes
22