2 Operation Verification; Operation Verification Tests; Error Code Verification Test; Hardware Validation Diagnostic Tests - Precor TRM700-16 Base Service Manual

2 Operation Verification
This section provides a method to verify that the treadmill is operating correctly and can be
returned to service. Do these operation verification tests at the end of a maintenance pro-
cedure or whenever it is necessary to ensure that the machine is operating properly.

Operation Verification Tests.

Error Code Verification Test

Verify that there are no current active error codes logged for this unit.
1. Go to the Error Log (or
error codes, see
2. Resolve any active logged error codes.
3. On P10, P20, and P30 clear the Error Log, see
page 145.
Hardware Validation Diagnostic Tests:
1. Access the diagnostics Hardware Validation Tests (access code 5,1,7,6,5,7,6,1) and
run the following tests:
P10, P20, and P30:
KEYPAD TEST () (select KEYPAD TEST): Follow prompts to run test.
l
DISPLAY TEST (select DISPLAY TEST): Follow prompts to run test.
l
INCLINE TEST (select MACHINE TEST > INCLINE TEST ).
l
BELT SPEED TEST (select MACHINE TEST > BELT TEST )
l
HEART RATE TEST (select HEART RATE TEST): Follow prompts run test.
l
P62, P80, and P82:
NUMERIC BACKLIGHT TEST (select SYSTEM TESTS > NUMERIC
l
BACKLIGHT TEST )
NUMERIC DISPLAY TEST (select SYSTEM TESTS > NUMERIC DISPLAY
l
TEST )
INCLINE TEST (select SYSTEM TESTS > INCLINE TEST ).
l
BELT SPEED TEST (select SYSTEM TESTS > BELT TEST )
l
HEART RATE TEST (select HEART RATE TEST): Follow prompts run test.
l
2. Exit Hardware validation Test: On P10, P20, and P30 press the RESET key to exit dia-
gnostics. On P62, P80, and P82 press Back to exit diagnostic and return to the Home
page.
1
Control Processing Assembly
Experience Series 700 Line Treadmills
1
CPA Event Log) and look for and record any active logged
"Error Log & CPA Event Log" on
2 Operation Verification
Operation Verification Tests.
page 145.
"Error Log & CPA Event Log" on
15