Precor TRM700-16 Base Service Manual page 58

Raising and supporting the treadmill
1. Connect the power cord and switch the input power ON.
2. Access the service menu (51765761) and select INCLINE TEST. Use the incline con-
trol to set the incline level to 14.
3. Securely and safely place supports (e.g. car jack stands) under the left and right front
corners of the frame weldment.
4. Slowly lower the incline level in 0.5 increments setting the frame onto the supports.
Verify the supports are stable carrying the weight of the treadmill and continue lowering
the incline level to "0". Incline level "0" is also the lift motor calibration reference incline
level.
IMPORTANT: Its important to set the incline level to "0" (calibration ref level) before
switching the power OFF.
5. Switch the power OFF and unplug the power cord.
Removing supports and lowering the treadmill
1. .Connect the power cord and switch the power ON. Be aware that switching the power
ON will cause the incline platform to move and return to the level "0" position.
WARNING: Keep hands and appendages clear of the incline platform assembly
before switching power ON. Switching power ON will cause the incline platform to
move to the level "0" Home position.
1. Access the service menu (51765761) and select the INCLINE TEST. Increase the
incline level enough to lift the treadmill frame off the supports.
Experience Series 700 Line Treadmills
4 Adjustment Procedures
Lift Motor Calibration
51