Precor TRM700-16 Base Service Manual page 48

1. Clean the running belt and deck, see
page 156.
2. Switch the power OFF and
3. Remove the front hood and left/right trim landing covers, see
Replacement" on
4. Make sure that the left and right Roller Keeper(s) are installed.
Note: TRM800-16 Treadmills - Some early production TRM800-16 treadmills may
only have one or no Roller keepers installed ( PPP000000302495102 RIGHT HAND
ROLLER KEEPER, PPP000000302495102 LEFT HAND ROLLER KEEPER).
5. Relax the running belt tension by loosening the left and right 5/16" hex key tension
adjustment bolts. Alternately loosen the left and right adjustment bolts in 1/4 turn incre-
ments to evenly remove tension.
Note: It is not necessary to remove the adjustment bolts. Loosen bolts until the take-
up roller adjustment cassett touches the frame. No further loosening is required. If the
bolt is removed, remove the trim end cap cover and reinstall the bolt.
CAUTION: Only use hand tools to adjust tension. Power tools can easily over and/or
under tension causing damage to the belt and/or tension hardware mechanism.
1
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
Experience Series 700 Line Treadmills
"Running Belt and Deck Cleaning Procedure" on
1
unplug the power cord.
page 54.
4 Adjustment Procedures
Running Belt Tension and Tracking Adjustment
"Covers and Panels
41