Panasonic KX-NS1000 Installation Manual page 339

Notice
The Slave unit will restart. Depending on the makeup of the network, it may take 15 minutes or more for
the unit to restart in Isolated mode.
Note
The Slave site can act in Isolated mode in the following conditions:
•
The connection to the Master site has failed.
•
The connection to the Backup master site has failed. (If a backup master exists in the One-look network)
•
The Isolated Mode setting is enabled in the Slave unit.
LED Indication
Operating
Status STATUS
Normal Green ON
Isolated Green ON
Mode
For more information about LED indications, refer to "LED Indications" in "4.3.1 Mother Board".
Note
When adding KX-NS700 PBXs as Slave units, the PBX MODE LED of each unit shows the One-look
network registration status instead of the MASTER LED of the KX-NS1000. For details, refer to the
Installation Manual of the corresponding PBX.
Similarly, the System Alarm button set for the flexible button on the PT lights to indicate the PBX status has
changed, and a message will be displayed on the LCD on the PT.
For details, refer to "12.1.4 Local Alarm Information" in the Feature Manual.
Isolated Mode Programming Procedure
Enabling Isolated Mode
The Isolated Mode setting is set to Disable by default.
Follow the procedure below to enable this setting using Web Maintenance Console.
Procedure
1.
Select the Slave unit to be programmed from the Home screen, or by using the site selection drop-down
menu.
2. Click Setup ® PBX Configuration ® Configuration ® Slot ® Site Property ® Main.
3.
Select Enable for Isolated Mode.
4.
Click OK.
Disabling Isolated Mode
You can disable the Isolated Mode setting using Web Maintenance Console.
Procedure
1.
Select the Slave unit to be programmed from the Home screen, or by using the site selection drop-down
menu.
2. Click Setup ® PBX Configuration ® Configuration ® Slot ® Site Property ® Main.
3.
Select Disable for Isolated Mode.
4.
Click OK.
Document Version 2016-03
Slave Unit
MASTER
LED LED
Amber ON
Red
Flashing
8.4.2 One-look Networking Survivability
Installation Manual 339