Panasonic KX-NS1000 Installation Manual page 59

Expandable Resources with Legacy Gateways
Connecting a PBX as a legacy gateway can expand the types of available resources. However, some types
of resources are not available. The following table shows the types of resources that are available when a
legacy gateway used with a KX-NS1000.
Notice
When legacy gateways are used with a KX-NS1000, all IP-PTs are registered to the KX-NS1000.
Therefore, no optional service cards nor DSP resources are required for the legacy gateways. For
information about unsupported optional service cards, refer to "Unsupported System Components for
Legacy Gateways" in "System Components".
Type
Optional Service Card
Terminal
Activation Key
IP terminals, except for KX-NT265 (software version 2.00 or later only), are registered and controlled by the KX-NS1000.
*1
Maximum Terminal Equipment
The following shows the number of each terminal equipment type supported by this PBX.
Notice
•
When 2 legacy gateways are used, the maximum number for each terminal equipment type for the
system is the sum of each PBX's maximum number. However, the maximum number of the following
terminal equipment does not depend on the number of legacy gateways.
–
IP-PTs (maximum number: 256
–
KX-NT505 Add-on 48 Key Module (maximum number: 64)
–
SIP phones (maximum number: 640
–
P-SIP extensions (maximum number: 640
–
IP-CSs (maximum number: 64)
–
PSs (maximum number: 512)
Document Version 2016-03
Physical Card for Legacy CO Lines and Extensions
Virtual Card
RMT Card
DPH/EIO/ECHO Card
ESVM/MSG Card
MEC Card
DSP Card
DPT/APT/SLT
PT-interface CS/CS for CSIF Card
PS
IP-CS/IP-PT/KX-UT Series SIP Phone
Doorphone
IP Softphone
KX-NT400
Any Activation key
/640 /256
*1 *2
/256
*1
Resource
)
*3
/384 )
*2 *3
/256 /384 )
*1 *2 *3
2.3.3 System Capacity
Availability
ü
–
*1
–
ü
–
–
–
ü
ü
ü
–
*1
ü
–
*1
–
–
Installation Manual 59